Nose,skrelationspresse.com,End,Steel,/hereinabove37741.html,Power Hand Tools , Power Tool Accessories , Milling Accessories,Niagara,Weldon,$113,N71367,Square,Cobalt,Mill,,Cutter $113 Niagara Cutter N71367 Cobalt Steel Square Nose End Mill, Weldon Power Hand Tools Power Tool Accessories Milling Accessories Niagara Cutter N71367 Cobalt Steel In stock Nose End Mill Square Weldon Niagara Cutter N71367 Cobalt Steel In stock Nose End Mill Square Weldon $113 Niagara Cutter N71367 Cobalt Steel Square Nose End Mill, Weldon Power Hand Tools Power Tool Accessories Milling Accessories Nose,skrelationspresse.com,End,Steel,/hereinabove37741.html,Power Hand Tools , Power Tool Accessories , Milling Accessories,Niagara,Weldon,$113,N71367,Square,Cobalt,Mill,,Cutter

Niagara Cutter N71367 Cobalt Steel In stock Nose End Mill Ranking TOP14 Square Weldon

Niagara Cutter N71367 Cobalt Steel Square Nose End Mill, Weldon

$113

Niagara Cutter N71367 Cobalt Steel Square Nose End Mill, Weldon

|||

Product description


The Niagara Cutter REM710 uncoated (bright) cobalt steel coarse-pitch rougher end mill has a non-center-cutting design and is suitable for machining soft, gummy materials such as aluminum or other nonferrous metals. The number of flutes varies by diameter to optimize the feed and cut rate. The coarse-pitch tooth design has chip-breaking cutting edges that remove more material in less time than conventional end mills to support heavier cuts at higher speeds. The end mill produces a rough finish that can be smoothed by a second finishing cut. The cobalt steel substrate can be run at faster speeds and stays sharp longer than high-speed steel tools, while offering resistance to heat and abrasion; this tool has no coating or surface treatment.
Rougher end mills are special-purpose tools whose chip-breaking cutting edges create small chips for heavy cuts and remove more material in less time than conventional end mills, with minimal vibration (chatter). The 30-degree helix angle balances lower angles’ strong cutting edge for difficult-to-machine materials with higher angles’ increased cutting action. The tool’s square end creates sharp, unrounded cuts and has a corner chamfer on the cutting edges to provide more strength than standard square end tools in applications where cutting forces are high. The non-center-cutting design is for applications such as peripheral milling. Cutting diameter tolerance is +0.003” to -0.000" for cutting diameters 1” or under; +0.006” to -0.000” for cutting diameters over 1”. The end mill has a Weldon shank.
End mills are designed to remove material and create multi-dimensional shapes and profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. The number of flutes can range from two to eight.

Niagara Cutter N71367 Cobalt Steel Square Nose End Mill, Weldon

Top